3 Interrupt %d was already used, and has been changed to %d.
4 There are no available interrupts. The sound card will not work.
5 The board is not at IO port %X, but was found at %X.
6 The OPTi 82c93x Audio board is not detected in your machine.
7 Both DMA channels must be the same. Setting both channels to %d.
8 DMA channel %d is not valid. Selecting channel %d.
11 The OPTi 82c93x Audio driver cannot located any synthesizer patches. MIDI will not work until you re-run setup.
21 The OPTi 82c93x Audio board is not responding properly. Please run setup.
22 An unexpected error has occurred
23 There are no available DMA channels. The sound card will not work.
24 The OPTi 82c93x Audio Driver cannot be removed because of a registry access problem.
29 DMA buffer size must be between 4 and 64.
30 OPTi 82c93x Audio Driver is not responding. Close down all volume controls and audio application and reconfig your driver. If this doesn't work, remove the OPTi 82c93x driver, reboot and re-install it.
31 Playback DMA channel %d must be paired with recording DMA channel %d for Full-Duplex. Defaulting to Half-Duplex Instead. Use Driver Setup to re-configure.
32 The OPTi 82c93x Audio board cannot be found with this port number. Check your settings and try again.
33 The MPU401 hardware cannot be found with this port. Check your settings and try again.
34 The MPU401 hardware cannot be found with this interrupt. Check your settings and try again.
35 Unexpeced error occurred during installation. Check your settings and try again.
36 The Interrupt is in use by another part of the system.
37 The MPU401 port address is in use by another part of the system.
38 There was insufficient memory to install the driver.